交通工具空氣彈簧的新型安裝方法:合理的安裝空氣彈簧能延長其運用保存生命的年數，在平時的維修中，對于已損傷或者漏氣的空氣彈簧，我們是需求及時進行更換的。那么，該怎么樣迅速的更換空氣彈簧呢？

   New installation method of vehicle air spring: reasonable installation of air spring can extend the use of the number of years to preserve life, in the usual maintenance, for the damage or leakage of air spring, we are in need of timely replacement.So, how to quickly replace the air spring?

   1.空氣彈簧安裝前，先在彈簧上下底座均勻涂抹潤滑油膠，以減少新空氣彈簧安裝時產生的磨擦力，同時盡量照顧空氣彈簧及其接觸位置不易受損。

   1. Before the air spring is installed, apply the lubricating oil glue evenly on the base above and below the spring to reduce the friction force generated during the installation of the new air spring, and try to take care of the air spring and its contact position is not easy to be damaged.

   2.將新空氣彈簧放于干燥的最簡單的面上，雙手用力量抓穩彈簧兩側，用力將彈簧向下壓至其大小足夠放入“上下底座”區間。

   2. Put the new air spring on the simplest dry surface, hold both sides of the spring firmly with both hands, and press down the spring until its size is large enough to be placed in the "up and down base" area.

   3.安裝時，先將空氣彈簧底部與下底座聯系，再調整彈簧頂部進入了上底座，待空氣彈簧基本放入上下底座之間時，掀開大氣的壓力閥對彈簧進行充氣，同時維修擔擔任職務務的人需雙手扶穩彈體，防止其過度移位。

   3. When installing, first connect the bottom of the air spring with the lower base, and then adjust the top of the spring into the upper base. When the air spring is basically placed between the upper and lower bases, lift the atmospheric pressure valve to inflate the spring.

   4.充氣10-15秒后，空氣彈簧充氣完結。此時用泡沫兒水噴灑散落在彈體上，仔細檢查新裝的空氣彈簧嚴密封閉性是否令稱呼心，彈體是否有破損，如無問題，則安裝完成，車輛可以正常營運。這種橡膠空氣彈簧安裝方法比較省時省力，并且獨自一個人就能完成。希望大家看了在這以后能有所收獲。

   4. After 10-15 seconds of inflation, the air spring inflation is completed.At this time with foam water spray scattered on the bullet body, carefully check the new air spring tight closure is called the heart, whether the bullet body is damaged, if there is no problem, then the installation is completed, the vehicle can operate normally.This rubber air spring installation method saves time and effort, and can be completed by a person.I hope you've seen this and you've seen it.